Istruzioni Duotronic Plus 07-04-2004 08:11 Pagina 16
To pause or to terminate the hydromassage press the key WATERPUMP ON/OFF @@. It
is possible to use the hydromassage without a programmed duration pressing directly the
key
@@
without selecting the duration.
How does the blower function
Choose the duration of the program by pressing the key SELECTION DURATION
PROGRAM
@@
between 10-20 and 30 minutes and start the blower by pressing BLOWER
ON/OFF @@.
You can regulate the desired airflow by pressing the key AIR REGULATION BLOWER @@.
To stop the blower press again the key BLOWER ON/OFF @@.
It is possible to activate the pulsating massage by pressing the key AIR REGULATION
BLOWER
@@
for 3 seconds. To terminate press the same key again.
Function spotlight
The spotlight works only with enough water in the bathtub by pressing the key LIGHT
ON/OFF @@.
As an option it is possible to order chromo therapy. For further information about this
function and about the various cycles available please consult page 18.
Function heater
The heater is optional and works only with enough water in the bathtub by pressing the
key HEATER ON/OFF @@. The heater maintains the watertemperature constantly at 38°C.
ATTENTION:
BEFORE ACTIVATING THE DISINFECTION CYCLE ASSURE YOURSELF THAT
THERE IS ENOUGH DISINFECTION LIQUID IN THE TANK AND ENOUGH WATER IN
THE BATHTUB.
Cleaning cycle
The cleaning cycle can be activated by pressing the key CLEANING CYCLE
@@
for 3
seconds. When the led is blinking there is not enough disinfection liquid in the tank and
you have to add the liquid.
When you press the key
@@
an acustic signal will be activated and at the same time the
spotlight will start blinking to indicate that disinfection fluid is injected in the bathtub (until
the spotlight is blinking you can still stop the disinfection program by pressing any key on
the display). After 10 seconds the liquid has been pumped in the bath. This time
determines the quantity of disinfection fluid and is programmed by Wilux based on the
dimensions of the bathtub.
The water pump starts automatically and cleans the tubes, now it is not possible
anymore to stop the cleaning cycle. After 3 minutes the pump stops and the bath can
be emptied. Approximately 8 minutes after the sensor feels no water in the bathtub the
light will stop blinking.
16