Ottobock 757Z184-2 Instrucciones De Uso página 11

Connect the two electrode cables and the 4-pole connection cable from
the terminal device to the battery receptacle (Fig. 7). Set the battery re-
ceptacle into the socket in such a way that the engaging lever is positioned
proximally. Insert the battery receptacle into the socket (Fig. 8) and then
press into the socket in place so that it is flush.
Attach the battery receptacle to the socket by screwing in both Allen Head
bolts with a SW 1.5 mm Allen Wrench (Fig. 9).
Attention!
The battery receptacle must not be glued into the socket!
7 Liability
Otto Bock Healthcare Products GmbH, hereafter referred to as manufacturer,
assumes liability only if the user complies with the processing, operating
and maintenance instructions as well as the service intervals. The manu-
facturer explicitly states that this product may only be used in combination
with components that were authorised by the manufacturer (see instructions
for use and catalogues). The manufacturer does not assume liability for
damage caused by component combinations which it did not authorise.
The product may only be opened and repaired by authorised Ottobock
technicians.
8 Trademarks
All denotations within this accompanying document are subject to the
provisions of the respective applicable trademark laws and the rights of
the respective owners, with no restrictions.
All brands, trade names or company names may be registered trademarks
and are subject to the rights of the respective owners.
Should trademarks in this accompanying document fail to be explicitly
identified as such, this does not justify the conclusion that the denotation
in question is free of third-party rights.
Ottobock | 11