Tabla De Contenido; Installation - STA-RITE PoolShark Manual De Uso

CONTENTS:
Safety ..............................................................................2
Installation ...................................................................3-6
Maintenance ...................................................................6
About "Fine-tuning" Vacuum
Adjustments and Connections.........................................7
Disassembly.................................................................8-9
Repair Parts ..............................................................10-11
Troubleshooting ............................................................12
Warranty .......................................................................13

INSTALLATION

Please use the convenient, water resistant, "Installation
Instructions" card.
Step 1: Install vacuum port door fitting
If there is no spring-loaded door on the vacuum port, in-
stall the included cover.
If you pool only has a skimmer, and no dedicated vac-
uum port, proceed to Step 2.
1. Screw the fitting into the port opening.
2. Orient the fitting so the arrow on the door points up.
Figure 1
3. Secure the cover by tightening the allen-screw below the
door.
Step 2: Straighten hose (Figure 2)
Remove and uncoil the hoses from the carton. Lay them
out in the sunlight, flat and straight.
Figure 2
Step 3: Check parts (Figure 3)
A. Pool Cleaner
B. Short Leader Hose (1 Length, 0.36 Meter)
C. Hose (10 Lengths, 1 Meter Each)
D. Hose Weights (2)
E. Eyeball diverters (2)
F. Reducer Cone
G. Vac Port Fitting
H. Regulator
J . Regulator Cap
K . Flow Gauge
• Short Extension Hose (not illustrated)
Figure 3
Step 4: Clean filter system (Figure 4)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
Figure 4
1882 0795
3
A B
C
D
E F
G
H K
J
3894
1880 0795