Rane ZONE POWER EIGHT Guia Del Usuario página 5

Setup
1. Use the included 3-pin Euroblock connectors to connect the Channel Inputs on the rear
panel to your audio sources. Each input has a ground (G), cold/negative (–), and
hot/positive (+) connector. See below for further instructions on the Euroblock connector.
2. Use the included 2-pin Euroblock connectors to connect the Channel Outputs on the rear
panel to your loudspeakers. Each output has a cold/negative (–) and hot/positive (+)
connector. See below for further instructions on the Euroblock connector.
3. Use the included power cable to connect the Power Input to a power outlet.
4. Power on all of your audio sources and Zone Power Eight.
5. Begin playing your audio sources. Adjust the volume knob for each Channel Input as
necessary.
Using the Euroblock Connector:
Use a small screwdriver to loosen the screws corresponding to the insert ports on the
1.
Euroblock connector.
Twist the speaker wire to form a tight strand and insert it into the appropriate insert port
2.
(following the +, -, and G labels on the rear panel of Zone Power Eight). Push the wire until
it is secured inside. Repeat this step for each port.
Tighten the screws corresponding to the insert ports on the Euroblock connector.
3.
Insert the Euroblock connector into the desired Channel Input or Channel Output on
4.
Zone Power Eight.
If you would like to disconnect a wire, first make sure you loosen the corresponding screw
on the Euroblock connector before you pull out the wire.
Channel 1 Output
Screws
Insert Ports
Speaker Wire
Euroblock
Connector
Channel 1 Input
Screws
Insert Ports
Speaker Wire
Euroblock
Connector
5