Installation Warnings; Safety Warning; Product Description - Fracarro SIG9606 Instrucciones De Uso

The product must be installed only by qualified persons, according to the local safety standards and
regulations. It is classified as Class II, in accordance with EN 60065 and, for this reason, it shall not be
connected to the protective earth (PE) of the supply mains.

Installation warnings

• Use only the original power cable, installing the product so that the mains plug is easily accessible.
• The product must not be exposed to dripping or splashing and thus it shall be installed indoors, in a
dry place.
• Don't install the product above or close to heat sources, in dusty places or where it might come into
contact with corrosive substances.
• Leave some space around the product housing (at least 5 cm) to ensure sufficient ventilation. An
excessive operating temperature and/or an excessive heating may affect the performance and the
life of the product.
• To prevent possibility of injury, the product must be securely attached to the wall or on the floor in
accordance with the mounting instructions given on Chapter 3.
In accordance with the European Directive 004/108/EC (EMC), the product shall be installed using
devices, cables and accessories that allow to comply with this directive requirements for fixed installa-
tions.
Earthing of the antenna system
The product must be connected to the earth electrode of the antenna system, in accordance with
standard EN 50083-1, section 10. The screw to be used for this scope is marked with the symbol
is recommended to follow the provisions of EN 50083-1 and not to connect the screw to the protective
earth (PE) of the supply mains.
IMPORTANT: Never remove the product cover, parts at hazardous voltage could be accessible when
the product case is opened. Only instructed and authorized persons can open the product. In case of
failure, do not try to repair it otherwise the guarantee will no longer be valid.
1
9
8
7
6
Compact headend for the reception and distribution of 6 digital terrestrial channels. Output channels
can be in VHF band or UHF band. Stereo version is also available (model SIG9606S).
The compact headend includes 6 digital receivers, 6 A/V modulators (mono modulator for SIG9606;
stereo modulator for SIG9606S), 6-way combiner with existing TV signal mixing, power supply and
programming unit. A/V outputs are available to connect optional modulators. The headend is suitable
for small and medium networks.

1. SAFETY WARNING

2. PRODUCT DESCRIPTION

10

5
1 - EARTH CONNECTION
 - TV INPUTS WITH
LOOP-THROUGH OUTPUT
3 - A/V OUTPUTS
4 - RF OUTPUT
5 - MIX-IN INPUT
6 - MAINS 0-40V
7 - PROGRAMMING UNIT
3
8 - GREEN LED (POWER ON)
9 - RED LED (ALARM)
10 - 1V AVAILABLE TO FEED
MAST AMPLIFIER
4
14
. It
∼