Preparation - Imetec N5001 Instrucciones De Uso

TYPE OF WATER
WARNING: TYPE OF WATER TO BE USED
This product is designed to work with fairly hard tap water (up
to 18°f).
For information about the hardness of your water, contact your water
supply company.
If fairly hard water (i.e. from 9°f to 18°f) is used, the filter must be set
on duration 1 (indicator light 8A); in this way, it allows about 25 hours
of ironing before needing to be replaced.
In the case of soft water (i.e. up to 8°f), the filter can be set on duration
2 (indicator light 8C), allowing about 40 hours of ironing before it has
to be replaced.
If the water is hard (i.e. from 18°f to 30°f), you are advised to use tap
water diluted with unscented demineralised water for irons (1:1) to
obtain a value of <18°f allowing you to set the filter on duration 1
(indicator light 8A).
In the case of particularly hard water (i.e >30°f), use unscented
demineralised water for irons or bottled mineral water (from a
supermarket). Not all mineral water is suitable however.
INSERTING THE ANTI-SCALE FILTER
NOTE: If the anti-scale filter (14) is not inserted or inserted incorrectly, the product will
not work.
Open the filter flap (2).
Remove the anti-scale filter (14) from its casing.
Remove the protective red rubber pads from the anti-scale filter (14).
Insert the anti-scale filter (14) in the housing and pressing firmly into position [Fig. B].
Closes the filter flap (2).
NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
This is absolutely normal and is caused by the anti-scale filter filling up. Hold the steam
request button (13) pressed for about 1 minute, until the buzzing stops and the iron begins
to deliver steam.

PREPARATION

EN
17