Care And Maintenance - sigel. luminous Serie Instrucciones De Uso

GB
LED TABLE TOP DISPLAY FRAME LUMINOUS
(TA420, TA422, TA423, TA424)
FIRST USE OF YOUR LED DISPLAY FRAME
1 // Open the cover of the battery compartment (fig. I, 2 ) underneath the
display frame.
2 // Insert either 2 or 4 1.5V AA batteries into the battery compartment.
Check that the batteries are inserted the right way around (+/-). For the
best levels of brightness and the longest burn time, 1.5V AA batteries are
recommended. A set of these batteries produces a burn time of approxi-
mately 250 hours. Please note: the brightness and burn time of the display
frame may vary depending on the quality of batteries used. Batteries are
not included. After inserting the batteries, replace the cover of the battery
compartment.
3 // Now switch the LED display frame on by pressing the switch (fig. I, 1 ).
To switch the display frame off, press the switch again.
INSERTING / SWAPPING CONTENTS
1 // Open the display frame by pushing the acrylic panel (Fig. II, 1 ) away
from the embedded magnets in the central panel (Fig. II, 2 ).
2 // For the best illumination effect, make sure the insert is lined up with
the top edge of the acrylic panel.
3 // Now slide the acrylic panel back down to line up with the central
panel. The embedded magnets keep the display frame securely closed.

CARE AND MAINTENANCE

Change the batteries when the display frame no longer lights up fully.
Remove the batteries if the display frame is not in use for a long period
of time.
Please use a soft dry cloth to clean this product. Do not use scouring
agents or solvents on the display frame! Avoid getting water inside the
frame.
6