When Using The Hung On Wall Unit - Pioneer PDP-S40 Manual De Instrucciones

English

When using the hung on wall unit:

First install the Plasma Display on the wall with only the speaker mounting fittings and speaker cable attached to the display,
and then attach the speaker.(See page 3)
Caution
Be careful about the speaker mounting fittings when installing or connecting. this may result in injury.
3. Connect the supplied speaker cables to the back of the Plasma Display.
4. Place the Plasma Display on the mounting fittings of the hung on wall unit.
• For details, refer to the instruction manual supplied with the hung on wall unit.
5. Connect the other end of the speaker cables to the speaker.
Speaker mounting screw
(M5 x 10 mm)
7. Tighten from below using the supplied screws (3 locations).
• Fix the center part of the speaker first with the supplied screws, then fix the right and left sides alike.
6
6. Place the speaker on the speaker mounting
fittings in the correct direction.
Speaker mounting screw
(M5 x 10 mm)
When using the hung on
wall unit, do not use these
holes.
Speaker mounting screw
(M5 x 10 mm)