Intended Use; Technical Description - Waeco MyFridge MF-1F Instrucciones De Uso

MF-1F.book Seite 11 Freitag, 3. März 2006 8:35 08
MF-1F
4

Intended use

The appliance is for cooling, heating or keeping warm drinks in suitable vessels.
Do not let yourself be distracted while driving.
The appliance is desgined for standard bottles: PET (polyethylene terephthalate) and
glass.
5

Technical description

The MyFridge thermoelectric bottle cooler (item no. MF-1F) is a compact cooler designed
for mobile use. It can cool drinks to around 22 °C under room temperature or warm them
to around 60 °C.
Its cooling system is a non-wearing and CFC-free Peltier cooling system with the heat dis-
charged by a fan.
6 Installing the bottle cooler
Observe the following installation instructions:
When fastening the bottle cooler in the vehicle, make sure:
– It cannot become loose under any circumstances (sudden braking, acci-
dents) and cause injuries to occupants of the vehicle.
– Bottles cannot roll out under the pedals.
If you want to fasten the bottle cooler with a self-tapping screws:
➤
Drill a hole where you want to fasten the appliance.
To prevent damage when drilling make sure there is sufficient space on the other
side for the drill head to come out.
➤
Deburr the hole.
➤ Screw the self-tapping screw (fig. 2 2, page 3) through the opening in the bottom of
the container.
If you want to fasten the bottle cooler with a machine bolt:
➤
Drill a hole where you want to fasten the appliance.
To prevent damage when drilling make sure there is sufficient space on the other
side for the drill head to come out.
➤
Push the machine bolt (fig. 2 3, page 3) through the opening in the bottom of the
container and fasten the bottle cooler with both washers (fig. 2 4, page 3) and the
nut (fig. 2 5, page 3).
If you do not want to permanently fasten the bottle cooler:
➤ If you do not want to permanently fasten the bottle cooler, put the dummy plug
(fig. 2 1, page 3) in the opening on the bottom of the container.
Intended use
11