Operating The Pump - Hayward Tristar VST Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 27

3. OPERATING THE PUMP

3.1 Power on
'Power' lights up and an LCD test runs on screen,
then the software version is displayed on screen
3.2 Priming phase
After switching on the pump, the priming phase starts automatically (this is the same after restarting the pump).
Priming phase begins automatically:
• The speed will climb to 3000 rpm and will last 240
seconds (default settings)
End of priming phase:
• The pump will stabilize at V2 by default or at the
last recorded speed.
• The corresponding LED lights up (Manual mode)
To display the remaining time of the priming phase:
• Press DISP/FUNC
• The remaining time is displayed in seconds
To stop the priming phase before it finishes:
• Press RUN/STOP
• The speed will stabilize by default at V2 or at the
last recorded speed
3.3 In Manual mode: selecting, setting and saving a custom speed
To select a speed:
• Press one of the speed preset buttons
• The default value will be displayed (in rpm)
• The corresponding LED will light up
To set a new speed:
• Press the up / down buttons
• The LED will blink: setting speed
• Choose the speed you want (between 600 and
3000 rpm)
To save the new speed:
• Press and hold the speed preset button for 3 s
• The LED will show a constant light once the speed
has been saved
Note: The water flow generated by the pump speed must be adapted to the volume capacity of the installed parts (filter,
pipes...). If you are unsure call a professional.
3.4 Stopping / restarting the pump
To stop the pump:
• Press RUN/STOP
• The pump will stop and the speed preset LED will
remain illuminated
• In Manual mode the screen will display 'StoP'
In Timer mode the screen will flash 'StoP'
To restart the pump:
• Press RUN/STOP
• The pump will begin its priming phase (section 3.2)
• Speed stabilization:
in Manual mode this will be the last recorded speed
in Timer mode this will be the operating speed of
the Timer preset
Page 6 of 12
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pr
>3s
Pump
88888
-r15-
. . . . .
3000
2400
219
2400
1500
1640
1640
StoP
StoP
1640
t2400
. .
Rev B

Publicidad

Tabla de contenido
loading

Tabla de contenido