Syncing Two Bases - TEMPUR-PEDIC ERGO Manual Del Propietário

syncing two bases

A Sync Cord is included with Twin Long and Split Cal King size bases.
The Sync Cord connects the two control boxes for the synchronization of two bases.
These steps are required in order to operate side-by-side Sleeptracker installations.
STEP 1
Unplug the base(s) from power source.
STEP 2
Disconnect the battery backup box cable from each Sleeptracker
Cable (make note where the cable was plugged in).
STEP 3
Connect the male end of each sync cord to the Sleeptracker
Insert it into the same port that you disconnected the battery backup box
from in Step 2.
STEP 4
Connect each battery backup box male connection to the sync cord
female connection (Refer to illustration at right).
STEP 5
Remove Sleeptracker Sensor cable from Sleeptracker
®
Base A and plug into open port on Sleeptracker
Make sure to properly route wires through rubber conduits. Disconnect
the Sleeptracker Processor on Base A by unplugging it from the USB
®
Extension Cable.
Sleeptracker
Sensor cable
A
B A
Smart
®
Smart Cable.
®
Processor on
®
Processor on Base B.
®
Sleeptracker Sleeptracker
®
®
Processor
Processor (B)
(A)
B
STEP 6
Plug bases back into the power source.
STEP 7
Check to ensure all cords are securely attached. Both remotes will now
operate both bases simultaneously.
The system is now linked. Pressed buttons on either remote will
control the two bases simultaneously.
Control Box 1
Sleeptracker
®
Smart Cable 1
Battery
Backup
Box 1
PERFORMANCE NOTES
®
If bases become mismatched, return both bases to the flat position to
re-sync the bases.
STEP 8
For both bases to operate independentely with their remote controls
instead of simultaneously, please use the Tempur-Pedic
to setup the bases as 'split'. This is generally preferred when using split
mattresses.
Return to page 8 step 4 for additional setup information.
Sync Cord
Control Box 2
Sleeptracker ®
Smart Cable 2
Battery
Backup
Box 2
Sleeptracker
®
app
®
15