Technical Specifications - Magic Care NASAL WASH Instrucciones De Uso

d 5. Fault identification
d
PROBLEMS
5.1 - If the nasal
wash dispenses
ut
too little or too
briefly.
nd
5.2 - If the nasal
wash does not
dispense the
solution
ons
he
NOTE: If, after checking the aforementioned conditions, the appliance still does not distribute the wash,
ng
we recommend that you contact your dealer or an authorised Flaem service centre.
s:

6. Technical specifications

ns
Model: Nasal Wash
or
Power supply voltage
Max dispensing chamber capacity
e,
Dispensing time for 10 ml of saline solution or spring water, approximately 2 minutes (1 ml in around 12
n
seconds) Oversize Cumulative Percentage in mass > 10 micron between 85 and 96 %
Nasal wash size
le
Nasal wash weight (without batteries)
Marking
Nasal wash batteries
o
Operating Conditions:
Storage conditions:
Operating/storage atmospheric pressure:
Disposal: Bear in mind that the product contains batteries and dispose of correctly. In compliance
with the Directive 2002/96/CE, the symbol printed on the device shows that the device to be
disposed of is considered waste and must therefore be an item of ''differentiated collection'' .
Consequently, the user must take it (or have it taken) to the differentiated collection sites provided
by the local authorities, or turn it in to the dealer when purchasing an equivalent new device.
Differentiated waste collection and the subsequent treatment, recycling and disposal procedures
promote the production of devices made with recycled materials and limit the negative effects on the
environment and on health caused by potential improper waste management. Unauthorised disposal
of the product by the user shall result in the application of administrative penalties, as per article 50 and
the subsequent revisions of Italian Legislative Decree no. 22/1997.
Electromagnetic compatibility
This device was designed to satisfy the current requirements for electromagnetic compatibility.
The manufacurer reserves the right to make technical and functional modifications to the product with
no prior warning.
The batteries may be running out. Change the batteries.
Check that the spray nozzle is inserted correctly (3).
Check that the spray nozzle is clean and, if not, clean the nozzle, following the
instructions provided in the manual carefully regarding Cleaning, sanitising
and disinfecting.
The batteries may be running out or incorrectly inserted. Change the batteries.
Check that the solution has been correctly poured into the dispensing
chamber(4a) of the upper body (4).
Check that the quantity of solution does not exceed 15 ml.
Check that the spray nozzle is clean and, if not, clean the nozzle, following the
instructions provided in the manual carefully regarding Cleaning, sanitising
and disinfecting.
SOLUTIONS
3.0 V 4.5 W
15 ml
7x6x15.5h cm
185 g
2 alkaline batteries 1.5 V (AA)
Temperaturemin 10°C; max 40°C
Air humidity: min 10%; max 75% RH
Temperature: min -10°C; max +35°C
Air humidity: min 10%; max 75% RH
min. 690 hPa; max. 1060 hPa P
13