Battery Installation; Turning The Unit On/Off - Topcom D’LITE MAGIC Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
Topcom D'lite Magic
3.2

Battery installation

The batteries are pre-installed. If they are not installed, follow the next instructions.
1.
Hold the upper part of the flashlight and turn the battery cover counter clockwise until
the part gets separated.
2.
Remove the battery compartment from the upper part and put the 3 included AAA
rechargeable batteries (600mAh NiMh) into the compartment following the indicated
polarity. Reinstall the battery compartment.
3.
Close the flashlight securely by turning the battery cover of the flashlight clockwise.
Do not install or try to recharge non-rechargeable batteries.
Only use the batteries supplied with the flashlight.
Do not short-circuit & dispose of in fire.
Remove the batteries if this device is not going to be used for a long
period.
Before use, charge the batteries for at least 8 hours.
4
Charging
Plug the charger into the wall socket.
Put the flashlight into the charger. The blue charging
LED will burn.
Because of two protection circuits against overcharging, the
unit can stay continuously in the charger. The LED light can feel warm during charging.
5
Using the D-Lite Magic
5.1

Turning the unit ON/OFF

While charging, pick up the flashlight. The LED light will automatically
power on.
When the flashlight is out of the charger, press the ON/OFF button to turn
the LED light on.
Press the ON/OFF button again to switch the light off or put the unit in the
charger.

Publicidad

Tabla de contenido
loading

Tabla de contenido