state. At this time in addition to the Bluetooth device can find and connect it. A minute later, if connectionless lights out and enter
the standby mode. If the Bluetooth connection by a player, the light flashes slowly, about 2-3 seconds flicker once. At this point you
can use the Bluetooth player playing music can hear the music of the corresponding channel.
11. POWER:
Power switch
12. PHONES LEVEL
This controls the output volume of the headphones. Care should be taken not to have this set to high as it could result in damage to
both the hearing of the user and the headphones. The channel to be monitored is selected via the cue assign control Knob.
13. CUE SELECTOR
Select each channel of the CUE signal
14. HEADPHONE
1/4' jack headphone out
15. CHANNEL 4
Line4 input/mic2 JACKS
16. CHANNEL 3
MP3/Bluetooth/Line3
17. CHANNEL 2
PHONO 2 INPUT/line2 JACKS
18. CHANNEL 1
PHONO 1 INPUT/line1 JACKS
Rear Panel:
1. MIC JACK
Microphones with a 1/4" connector can be connected to these input terminals.
2. LINE INPUTS
Let you connect most high-level audio source, such as CD players, tape deck, tuner or VCR.
3. GROUND
Ground Screw for turntables.
4. REC OUT
Line level Unbalanced RCA connectors.
5. RCA MASTER OUTPUTS
Left & Right line level Unbalanced RCA outputs.
6. POWER INPUT
Please ensure the correct voltage is selected for your country. Failure to set the correct voltage will cause damage to the unit.
SPECIFICATIONS:
INPUTS:
DJ MIC .............................................................................................................................. 1.5mv/1K Ohm balanced
PHONO .............................................................................................................................................. 3mv/680 Ohm
LINE ............................................................................................................................................... 150mv/27K Ohm
OUTPUTS:
REC .................................................................................................................................................. 350mv/5K6 Ohm
MASTER .................................................................................................................................................. 1V/5K6 Ohm
GENERAL:
Frequency Response ................................................................................................................. 20Hz-20KHz @ ±2dB
THD .................................................................................................................................................................. 0.1%
S/N Ratio ........................................................................................................................................................ >80 d B
Headphone Impedance ................................................................................................................................. 32 Ohm
©Copyright LOTRONIC 2016
4
DJM90USB-BT