cecotec ForceTitanium 650 Manual De Instrucciones página 20

ENGLISH
indicates that the iron is heating up. Wait until the temperature indicator light turns off before
ironing.
WARNING: the temperature indicator light (G) will turn on and off at intervals, indicating
that the selected temperature is maintained. If you lower the temperature after ironing
at a high temperature, do not start ironing until the temperature indicator light turns on
again.
CAUTION: leave the steam selector off.
Anti-calc function
The anti-calc function is a permanent system located inside the water tank to eliminate
impurities from the water and reduce the problems derived from limescale build-up. To
prolong the efficiency of this system, follow these steps regularly:
1. Unplug the iron and allow it to cool down.
2. Fill 3/4 of the measuring cup provided with the iron with water. Add 1 teaspoon of salt and
fill the water tank with this solution.
3. Leave the solution in the water tank for 15 minutes, shaking it occasionally, and empty it.
Repeat this step twice.
4. Fill the tank with fresh water to rinse it and empty it.
Anti-drip function
This system controls the water flow to the soleplate at all times. Below a certain temperature,
the anti-drip function cuts off the water flow and prevents the iron from dripping water onto
the fabric.
Auto-power off function
The iron will automatically turn off if placed in horizontal position for 30 seconds, or in the
vertical position for 8 minutes. To indicate that the iron has been turned off, the unit will beep
6 times and the auto-power off indicator light will blink. The iron can take up to 45-60 minutes
to cool down completely. To heat up the iron again:
1. Pick up the iron or move it slightly.
2. The auto-power off light indicator will stop blinking.
3. The auto-power off light indicator will remain on and the iron will be ready for use.
How to use the water Spray :
Before using the Spray function, check the fabric label for ironing instructions, as some fabrics
may be spotted or stained with moisture. The Spray function is particularly helpful to remove
stubborn wrinkles and whenever extra moisture is needed. The Spray may be used both with
steam or dry ironing. Simply press the Spray mist button when desired.
20 FORCETITANIUM 650
05106_ForceTitanium 650_Manual_DS.indd 20 21/12/18 8:54