Emerio FN-110477.2 Manual De Instrucciones página 5

FN-110477.2
PARTS DESCRIPTION
1. Front guard
2. Guard securing clip
3. Blade fastening screw
4. Blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Shaft pin
9. Oscillation knob
ASSEMBLING INSTRUCTIONS
Base and Standing Shaft Assembly
1. Insert the lower standing shaft (14) into the hole of standing base (16), keeping the bulge (17) of standing
shaft aligned with the space (18) of the base hole. Use four screws to fix the lower standing shaft.
2. Insert the upper standing shaft (13) into the lower standing shaft (14), turning the upper standing shaft (13)
clockwise to tighten the connection of two shafts.
The Whole Assembly
1. Remove the blade fastening screw (3) and guard fastening screw (5) from the motor shaft (7) spindle.
2. Fit the rear guard (6) by positioning with the location pins. Secure the guard onto the motor body with the
guard fastening screw (5).
3. Place the fan blade (4) onto the motor shaft by matching the slot with the shaft pin (8). Fix the blade by
tightening the blade fastening screw (3) in a counter-clockwise direction. Check that the fan blade can rotate
freely by turning it with your hand.
4. Loosen the clip screw on the guard securing clip (2) and open the guard securing clip. Position the top clip of
front guard (1) onto the uppermost part of the rear guard (6). Press the rim of front guard onto the rear
guard. Close the bottom clip and tighten the screw.
10. Handle
11. Power cord
12. Speed control buttons
13. Upper standing shaft
14. Lower standing shaft
15. Screws
16. Standing base
17. Bulge
18. Space
- 4 -
EN