cecotec Conga 3290 Titanium Manual De Instrucciones página 31

robot will smartly return to the charging base automatically and, once it is fully charged, it
will resume the cleaning process from the same point, offering a high-effi ciency cleaning.
During cleaning, the robot will stop briefl y to evaluate the area and calculate the cleaning
route (this stop will vary depending on the house conditions).
Warning: The robot cleans in an organized way and per squared 4 x 4 m areas, therefore it
might leave the room where it is cleaning to fi nish off the delimited area. Do not worry about
this, the robot will clean all the accessible surface.
2. Edge mode
Press the on the App for the robot to start cleaning under
this mode. It will automatically start cleaning along all the
surface's perimeters and then will return to the charging base
direct and automatically. If the robot has not started cleaning
from the charging base, it will return to the starting point.
Note: press the POWER button to switch between the 3 modes
Turbo/Normal/Eco.
3. Back-home mode
Press the button on the App to send the robot to the charging base. The robot will take the
shortest route back to the charging base thanks to its map memorizing and the smart back-
home function.
When a cleaning cycle has been completed or the robot's battery
is low, thanks to its TotalClean 2.0 technology, the robot will also
return to the charging base to avoid running out of battery. Once
the robot has recharged, it will resume cleaning from the exact
point it has stopped.
Notes:
• Remove the Wet & dry tank from the robot before charging it.
• Make sure there are no obstacles in the room being cleaned to ensure the robot can get
to the charging base without problems.
ENGLISH
31