Error Messages - Dirna Bycool DINAMIC 1.1 Manual Del Usuario

DINAMIC 1.1
EN
Hours de functioning and switching off from 0 to 9 hours. On 0 hour, it does not temporise, it
is in manual functioning F0.
To select hours, user will employ
Choose hour which appears on display, 1H (one hour), 2H (two hours)....9H (nine hours),
and push ON/OFF
and will stop when this time period is over.
F3 Low consumption module (Stand-by)
If equipment does not work for 6 to 8 days, it will also go into Stand-by . For equipment to
start again, push manually ON/OFF
To activate this function, keep the ON/OFF
F6, and then release the key to directly enable ºF. To return to ºC, keep the
control panel pressed down with the display flashing C
press the key on the control panel. The control is disabled when carrying out this
operation, meaning it must be registered again once finished.
!
If when equipment is switched on, it makes continuous noises, it means that keyboard is
badly connected or not connected.
E0 - Recirculation probe failure.
E1 - Low battery, less than 22.8V.
E2 - Electric fan failure or blower failure.
E3 - Compressor failure
(Causes: engine, wiring, connector,
lack or excess of charge)
F2 Time programming
keys.
select F4 ó F0 , equipment will be working during selected time
key.
F6 Function: ºF Selection

Error messages

8
key pressed down until the display shows
, when it stops flashing,
E5 - Failure due to overheating of control
module.
E6 - Anti-ice probe failure.
Ec - Communications cable failure.
dirna
, s.a.
key on the