HQ-Power VDPLPS36B2 Manual Del Usuario página 4

• Make sure the housing never touches surrounding surfaces or objects.
• Do not operate the device in surroundings where water, rain, moisture or fog may harm the device. When using
smoke machines, make sure the device is never exposed to the direct smoke jet and is installed at a distance of
0.5m from the smoke output.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat (see "Technical Specifications"), dust and
moisture. Respect a minimum distance of 0.5m between the device's light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people. Any damage that may occur will most probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
• The installation has to be approved by an expert before the device is taken into service.
4. Installation
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The construction to which the device is attached should be able to support 10 times the weight of the device for
one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable (e.g. VDLSC8).
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used. Have the material and the device itself checked regularly. Do not attempt to install the device
yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• If the spot shall be lowered from the ceiling, professional trussing systems have to be used. The spot must never
be swinging freely in the room. A spot may cause severe injuries when crashing down. If you have doubts
concerning the safety of the installation, do not install the spot.
• Mount the spot by attaching the mounting bracket to the trussing system and by using an appropriate clamp.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Don't connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Connection
With a DMX512 signal, please connect the cables as below:
XLR pin
1
2
3
FUNCTION: these 4 switches set the function mode of the spot
PATTERN: address setting
SPEED: manual speed adjustment
MUSIC: sensitivity control for the built-in microphone
VDPLPS36B2/VDPLPS36C2
Signal
Ground
Signal -
Signal +
4 HQPOWER