Velleman CHLS16C Manual Del Usuario página 6

question.
• In case of the 4‐channel CHLS16C, you will have to set the start address of
the first unit to 1 (CH1~4), the second unit to 5 (1 + 4) (CH5~9), the third to
9 (5+4) (CH10~14), and so on.
Note: CH1 = red, CH2 = green, CH3 = blue, CH4 = white
• Set switch number 10 of the DIP switch [10] to ON (up) to select DMX512
mode.
• Set the start address on the other nine DIP switches [10].
switch
value
6. Operation
• Make sure all connections are properly made and switch on the power.
• When using DMX control, make sure the first switches of the DIP switch
[10] are set to the correct DMX address and the last switch is set to ON. No
further user intervention is required.
• When using the controller stand‐alone, make sure the last switch of the
DIP switch [10] is set to OFF. The rest of the switches have no meaning.
• Aim the remote control IR LED [A] towards the IR LED [3].
• Press the ON button [B] to switch the LED strip on.
• Press the pre‐programmed buttons [G] multiple times to scroll through the
desired effect (see table below).
1. red / 2. red+white / 3. gradual change red~white / 4. flash change
red~white / 5. red dim~bright / 6. red flash
1. green / 2. green+white / 3. gradual change green~white / 4. flash
change green~white / 5. green dim~bright / 6. green flash
1. blue / 2. blue+white / 3. gradual change blue~white / 4. flash change
blue~white / 5. blue dim~bright / 6. blue flash
1. yellow / 2. yellow+white / 3. gradual change yellow~white / 4. flash
change yellow~white / 5. yellow dim~bright / 6. yellow flash
1. cyan / 2. cyan+white / 3. gradual change cyan~white / 4. flash change
cyan~white / 5. cyan dim~bright / 6. cyan flash
1. purple / 2. purple+white / 3. gradual change purple~white / 4. flash
change purple~white / 5. purple dim~bright / 6. cyan flash
1. white (W) / 2. RGB+white / 3. white dim~bright / 4. gradual change R‐
W‐G‐W‐B‐W‐Y‐W‐C‐W‐P‐W / 5. Gradual change R‐G‐B‐Y‐C‐P‐W / 6. flash
change R‐G‐B‐Y‐C‐P‐W / 7. Flash change R‐G‐B
• Use the mode up/down buttons [D] to scroll through all available pre‐
programmed modes (see table above).
• Use the speed up/down buttons [E] to increase/decrease effect speed in
gradual changing or step changing mode.
• Adjust the output brightness with the BRIGHT button [F]. Only available in
29.11.2010
1 2
1 2
e.g.
CHLS16C
3 4 5
4 8 16
= start address 5
6
6 7 8
32 64 128 256
©Velleman nv
9