Motor Unit - VOX electronics CES-3001 Manual De Usuario

KNOW YOUR CITRUS JUICER
Big reamer
Small reamer
Juice bowl
Rotating shaft

Motor unit

USING YOUR JUICER
Before first use, clean the top lid, reamer, filter and cup thoroughly with warm water.
1. Place the cup on the base, then assemble the sieve into the spindle cap and afterwards
assemble the reamer into the spindle cap. Please assemble in sequence.
2. Halve the fruit, put the fruit on the reamer and press it lightly and the motor starts running.
The extracted juice will flow into the cup through the sieve, rough flesh and pith will remain
on the sieve. The motor may rotate in different direction.
Caution: Never exert excessive force when pressing the fruit as it may result in blocking
and damaging the motor.
3. When squeezing is finished, release the hand from the reamer and the motor stops running.
The appliance is in the idle state. You may restart it again any time by pressing the reamer
down.
4. After extracting, put the reamer away before poring juice.
Caution: The appliance shall be on for 15 seconds and off for 15 seconds and after 10
consecutive cycles, the appliance must be cooled for 30 minutes.
Note: the max capacity of the cup is 1.0 L. Make sure you do not overfill the cup.
Top lid
Sieve