Range Of Application; Servicing And Maintenance - Jackson WH05 FLIP Manual De Instrucciones

e JACKSON SAFETY FLIP USER MANUAL
Jackson Safety Flip helmets offer permanent protection against UV/IR rays, also heat and sparks caused by the
welding process. Do not look directly at the welding rays with unprotected eyes when the arc strikes. This can cause
painful inflammation of the cornea and irreparable damage to the lens of the eye leading to cataracts

RANGE OF APPLICATION:

The Jackson Flip welding helmet is supplied with a shade 11 mineral glass. The Jackson Flip welding helmets can be
used for the following applications:
• E Manual with flux core or fluxed stick suitable internal currents in the range 80 -175 amperes
• MIG suitable internal currents in the range 100 -175 amperes
• TIG suitable internal currents in the range 100 -175 amperes
• MAG suitable internal currents in the range 80 -125 amperes
• Electric Arc suitable internal currents in the range 175 - 225 amperes
• Plasma Cutting all weldable metal suitable internal current in the range 60 -150 amperes
• Plasma Cutting micro-plasma cutting suitable internal current in the range 30 - 60 amperes
ADJUSTMENT OF HEADGEAR:
Jackson Flip helmets are fitted with a comfortable head gear which can be adjusted in 4 different ways. See drawing
1.
REPLACING THE SPATTER LENSES:
Ensure that the helmet is always fitted with an Outer and Inner protection lens.
These protection lenses must be replaced if broken, damaged or covered with welding spatter to the extent that
vision is impaired.
Outer and Inner protection lenses are consumables and must be replaced regularly with genuine certified Jackson
spare parts.
Before using the Jackson Flip helmet for the first time the protective film that covers the protection lenses must be
removed from both sides of the lens. See drawing 2.
INSERTING AND REMOVING THE PROTECTION LENSES:
The Inner protection lens is easily removed by pushing it outwards from the inside of the helmet. To insert the lens, it
is necessary to fit the lens under the 2 tabs located at both sides on the main aperture. See drawing 3.
The Outer lens sits on top of the Welding filter and is retained by a plastic clip. To remove and replace the plastic clip,
pull the clip inwards towards the center of the lens releasing it for It's catch. The clip can then be removed and the
lenses changed. To fit the clip, insert one side into the catch and then force the other side into place. See drawing 3.

SERVICING AND MAINTENANCE:

Always make sure not to place heavy objects or tools (hammers etc.) on or inside the helmet so as not to damage
the optical filter. Always make sure that the helmet is equipped with an outside and inner lens (in front of the filter
on the outside and on the inside behind the filter). These protection lenses must be replaced if damaged in any way.
They are consumables and should checked and replaced regularly. The filter should be cleaned when changing the
protection lenses. This can be done by any of the following ways:
• Wipe with a clean, dry piece of cloth.
• Clean with a piece of smooth cloth moistened with pure alcohol.
• Clean with a commercial disinfectant
• If used properly the welding filter requires no further maintenance during its lifetime.
If a filter should be replaced on a Jackson Flip welding helmet, use exclusively certified products (CE marks). We
recommend the use of Jackson welding filters in all Jackson Flip helmets.
We recommend you to use the welding helmet for a period of 10 years. The duration of use depends on various
factors such as way of use, cleaning, storage and maintenance. Frequent inspections and replacement in case of
damage are recommended.
WARNING:
Welding helmets can only resist a certain amount of heat. Please do not place hot electrode holders inside the helmet
and please do not place the helmet near naked flames or hot work surfaces.
Materials that may get in contact with the wearers skin could cause Allergic reactions to susceptible individuals.