Tabla de contenido
Publicidad
DESCRIPTION
The appliance you have purchased is a metal
construction, centrifugal in-line extractor fan,
designed to expel air through a ventilation duct.
WARNING - CAUTION
!
Warning:
• Do not use this appliance for functions other than
those described in this instruction booklet.
• After removing the appliance from its packaging,
ensure that it is complete and undamaged.
If in doubt contact a professionally qualified
electrician or Vortice*. Do not leave packaging within
the reach of children or the infirm.
• Certain fundamental rules must be observed when
using any electrical appliance, including: a) never
touch appliances with wet or damp hands; b) never
touch appliances while barefoot; c) do not allow
* Or an authorised Service Centre if you are outside the UK-Ireland territory.
!
Caution:
this symbol indicates precautions that must be taken to avoid damage to the appliance.
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• The inside of the appliance should only be cleaned
by qualified personnel (figs. 21-22-23).
• Do not immerse the appliance or any parts of it in
water or other liquids. Refer to the relevant
instructions to clean the appliance (fig. 24).
• Regularly inspect the appliance for visible defects.
If any faults are found, do not operate the appliance
but contact Vortice* immediately.
• If the appliance malfunctions or develops a fault,
contact Vortice* immediately. Ensure that only
genuine Vortice spares are used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice*.
• The appliance must be installed by a professionally
qualified electrician.
• The electrical system to which the appliance is
connected must conform to applicable standards.
• The appliance must be correctly connected to an
efficient earthing system conforming to applicable
electrical safety standards. If in doubt, ask a
professionally qualified electrician to perform a
thorough check.
• The electrical power supply/socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance. If it cannot do this, contact an
electrician to make the necessary modifications.
• A multipolar switch must be used to install the
appliance. The gap between the switch contacts
must be no less than 3 mm.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function
* Or an authorised Service Centre if you are outside the UK-Ireland territory.
this symbol indicates precautions that must be taken to avoid personal injury.
young children or infirm persons to use the appliance
without supervision; d) supervise young children to
ensure that they do not play with the appliance.
• Store the appliance out of reach of children and
infirm people when it is disconnected from the
power supply and no longer in use.
• Do not operate the appliance in the presence of
inflammable vapours (alcohol, insecticides, petrol,
etc.).
• Do not sit on or place objects on or in the appliance.
correctly; b) before cleaning the outside of the
appliance; c) if the appliance is not going to be
used for any length of time.
• The appliance must not be used to switch on and off
water heaters, stoves, etc., nor must it be connected
to the hot air ducts used by other appliances.
• The room must have an adequate source of
replacement air for this appliance to function effectively.
Moreover, if there is any non-sealed combustion based
appliance such as a water heater, gas stove, etc. in the
same room, air replacement must be sufficient for all
appliances to work effectively together.
• Ensure that the appliance exhausts into a single
duct dedicated solely to this appliance.
• Keep the appliance's inlet and outlet grilles free to
ensure an optimum flow of air.
• The appliance's outlet port must always be
connected to a suitable duct.
• The motors of all models are equipped with thermal
cut-outs that can be reset manually. If the thermal
cut-out trips, disconnect the appliance from the
mains supply for a few minutes and reconnect it
only after identifying and correcting the problem.
• The maximum ambient temperature for the proper
functioning of the appliance is as follows:
CA 100 - 125 - 150 - 160 - 200 = Max 55°C
CA 250 - 315 = Max 50°C
CA 100 Q - 125 Q - 160 Q - 200 Q - 250 Q = Max 55°C
CA 315 Q = Max 55°C
• Use of the supplied brackets is optional (see figures
6 to 12).
N.B.
If the appliance is installed without a duct attached
to its inlet port (i.e. with an open air intake) and at
a height below 2.3 metres,a protective grille must
be fitted over the inlet port (see page 30).
ENGLISH
7
Publicidad
Tabla de contenido
