Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 82

IMPORTANT

The lightning flash with arrowhead
symbol, within an equilateral
triangle, is intended to alert the
user to the presence of uninsulated
"dangerous voltage" within the
product's enclosure that may be of
sufficient magnitude to constitute a
risk of electric shock to persons.
WARNING
This equipment is not waterproof. To prevent a fire or
shock hazard, do not place any container filled with liquid
near this equipment (such as a vase or flower pot) or
expose it to dripping, splashing, rain or moisture.
WARNING
Before plugging in for the first time, read the following
section carefully.
The voltage of the available power supply differs
according to country or region. Be sure that the power
supply voltage of the area where this unit will be used
meets the required voltage (e.g., 230 V or 120 V) written
on the AC adapter label.
WARNING
To prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
VENTILATION CAUTION
When installing this unit, make sure to leave space around
the unit for ventilation to improve heat radiation (at least
15 cm at top, 5 cm at rear, and 1 cm at each side).
WARNING
Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the product,
and to protect it from overheating. To prevent fire hazard,
the openings should never be blocked or covered with
items (such as newspapers, table-cloths, curtains) or by
operating the equipment on thick carpet or a bed.
WARNING
Store small parts out of the reach of children and infants. If
accidentally swallowed, contact a doctor immediately.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF
ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
Operating Environment
Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
D3-4-2-1-3_A1_En
strong artificial light)
If the AC plug of this unit does not match the AC
outlet you want to use, the plug must be removed and
appropriate one fitted. Replacement and mounting of
an AC plug on the power supply cord of this unit should
be performed only by qualified service personnel.
If connected to an AC outlet, the cut-off plug can
cause severe electrical shock. Make sure it is properly
D3-4-2-1-4*_A1_En
disposed of after removal.
The equipment should be disconnected by removing the
mains plug from the wall socket when left unused for a
long period of time (for example, when on vacation).
D3-4-2-1-7a_A1_En
CAUTION
 button on this unit will not completely shut off all
power from the AC outlet. Since the power cord serves
as the main disconnect device for the unit, you will need
to unplug it from the AC outlet to shut down all power.
Therefore, make sure the unit has been installed so
that the power cord can be easily unplugged from the
AC outlet in case of an accident. To avoid fire hazard,
the power cord should also be unplugged from the AC
outlet when left unused for a long period of time (for
example, when on vacation).
When using this product, confirm the safety information
D3-4-2-1-7b*_A1_En
shown on the bottom of the unit and the AC adapter
label.
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which requires
repair will be charged for even during the warranty
period.
2
The exclamation point within an
equilateral triangle is intended
to alert the user to the presence
of important operating and
maintenance (servicing) instructions
in the literature accompanying the
appliance.
D3-4-2-1-1_A1_En
D3-4-2-1-7c*_A1_En
D3-4-2-2-1a_A1_En
D3-4-2-2-2a*_A1_En
D3-4-2-2-4_B1_En
K041_A1_En

Publicidad

Tabla de contenido
loading

Tabla de contenido