Basic Operation; Setting Mode - Esoteric D-02X Manual Del Usuario

Basic operation

1
Press the POWER button to turn the unit on.
Press the POWER button in completely until it stops .
When on, the ring around the POWER button lights blue .
2
Press the INPUT button to select the source.
Each time you press the INPUT button, the active input changes
in the following order and is shown on the display .
ESLINK DUAL
USB OPT
Select the input and start playback from the audio source device .
If no digital signal is detected, no sampling frequency will be
shown to the right of the word "INPUT" on the display . Confirm
the connections before turning connected devices on .
o When you are done using this unit, press the POWER button
to turn it off .
12
XLR1 XLR2
RCA2 RCA1

Setting mode

1
Press the MENU button repeatedly to select the
desired setting item.
Each time you press the MENU button, the item shown on the
display changes .
UPCONV>
c
DSD_F>
c
CLK>
c
CLKin>
c
CLK_TH>
Press the INPUT button or do nothing for 10 seconds to exit set-
ting mode and return to the ordinary display .
2
Use the parameter adjustment (−/+) buttons to
change the settings.
For information about settings, see pages13–16 .
Setting mode will end and the ordinary display will reappear if
nothing is done for 10 seconds or the INPUT button is pressed
once .
o Settings are retained even if the power plug is disconnected .
APS>
3
DPaOFF>
3
AOUT>
3
DIMMER>