MADISON FREESOUND-VINTAGE15 Manual De Usuario página 2

Contents of the carton
1x Bluetooth speaker FREESOUND-VINTAGE15
1x USB charging cable
1x 3.5mm AUX lead
1x manual
Warnings:
The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed
on the apparatus.
For indoor use only
Do not place on the apparatus as naked flame source, such as lighted candles.
Do not use the unit in a tropical climate. Only for use in temperate climates.
In conformity with RoHs standard
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Charging the Bluetooth Speaker
Plug the mini-USB connector of the USB charging lead into the 5V DC socket on the rear panel of the radio and the
other end into a suitable USB port or a mains adaptor.
Location of controls
1. ON/OFF switch
2. LED indicator for charging
3. Mode indicator
4. Volume control
5. AUX IN jack
6. Micro USB charging port
Pairing the speaker with a Bluetooth enabled device
Keep the speaker and the Bluetooth device within 1m of each other during the pairing process. Push the ON/OFF
switch to ON position. A tone is heard and the Bluetooth LED indicator will flash blue. Set your mobile phone or other
Bluetooth enabled device to search for Bluetooth devices. When the Bluetooth device finds the speaker, select
MADISON in the list of found devices. After a successful pairing, a tone will be heard and the Bluetooth LED indicator
will slowly flash blue.
If a previously paired device is in the range when the speaker is turned on, the speaker will connect to it
automatically.
Using as a Wired Speaker
To use the speaker as a wired device, plug one end of the 3.5 auxiliary cable into the AUX jack on the top panel of the
GB
BLUETOOTH VINTAGE SPEAKER
2