Technical Specifications; Charging Instructions - BS Charger BA 10 Manual De Instrucciones

BATTERY TYPES & CAPACITY
•
Suits all Lead Acid Type Batteries (Conventional, AGM & Gel) and lithium (LiFePO4)...
•
Selectable 6 Volt & 12 Volt Output.
• Battery Capacity: The following maximum AH capacities are to be used as a general guide only: some batteries maybe able to
handle a higher Charge Current. Check with the battery Manufacturer when charging batteries with small capacity.
Charge current
Battery capacity: charging
Battery capacity: maintaining
ELECTRICAL PARTS
Delivered with:
•
Input Connector: 6 feet with 2PIN plug or wall mount.
• Output Cord: 4 feet with Quick Connector.
• Extend Cord: 2 feet with Crocodile Clips / Ring Terminals.
ENVIRONMENTAL CHARACTERISTICS
•
Operating temperature: 0 to 45° C.
•
Storage temperature: -25 to 85°C.
• Operating humidity range: 0 to 90% RH.
• Cooling: passive / natural.

TECHNICAL SPECIFICATIONS

Part number
Type
Approvals
Input voltage range
Input frequency
Output
Size (LxWxH) in mm
Weight

CHARGING INSTRUCTIONS

STEP 1 - Pre Charge Check & Electrolyte Level Check
•
Check the Battery Electrolyte level (Not required on sealed & Maintenance Free Batteries). If necessary, remove the vent caps and
add distilled water so the levels are halfway between the upper and lower fill lines.
• Check the Voltage Output Switch on the charger and make sure it's on the correct voltage.
STEP 2 - Connecting the Battery charger to your Battery
•
If the Battery is out of the vehicle:
-
Connect the Red lead from the charger to the positive (+) battery terminal.
-
Connect the Black lead from the charger to the negative (-) battery terminal.
| www.bs-battery.com
1A
2-20Ah
2-40Ah
CE, NZS, SAA
100-240V
Red
BA10
Automatic
UL, CUL
120V
50/60Hz
1A @ 6/12V
105x68x35
0.4Kg
BLACK
4