Getting Started - Ribimex Ribiland PRD22P Manual De Uso

The operator and/or user must use common sense and caution when operating the product especially
for any matters that are not referred in the above
SAFETY INSTRUCTIONS SPECIFIC TO THE PRODUCT
(a) Do not open / modify the hose reel. Never open the hose reel and never modify it.
(b) Check pressure resistance. Compare the information on the rating plate with those mentioned
on your water supply.
(c) Never connect or use with a high pressure washer. Bursting hazard of the hose or damaged to
the fittings.
(d) Stop using if damaged. Stop using the hose reel in case of malfunctions and defects / damage.
Impacts or cuts to the hose can cause damage.
(e) Protect the hose. Protect the hose against chemicals avoiding contact with products such as oil,
acids, corrosives liquids; ...
Protect the hose against mechanical risks such as pinching, crushing, jamming, torsion solicitations;
impacts; sharp edges and/or sharp points; situations where the hose might be tread upon or rolled
over ...
Protect the hose against risk of direct exposure to sun light; very hot temperatures; very low
temperatures; ...
Product may get damaged in case of non-compliance with these instructions.
IV. GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage.
- Content: 1 hose reel; 2 quick connectors; 1 tap connector; 1 spray gun; 1 wall bracket with pivot
point; 1 screw kit (4 screws, 4 masonry plugs); 1 user manual.
4.2- Installation
WARNING: If not properly installed, there is a risk of falling. Make sure your installation can
support the loads.
WARNING: This hose reel is not recommended for ceiling-mount applications.
Choosing a location
This reel is best installed close to a source of water.
For a large area, please place it in the centre of the work area and then you can extend the hose to the
most convenient point in this area.
The hose reel must be mounted on a strong surface, due to product's weight when full of water and the
pulling action during use.
We recommend to mount the bracket on a wall (concrete or brick) or timber (solid wood).
There are many alternative positions in which the unit can be placed.
The key point is subject to what is convenient for the user.
The most appropriate position is to mount the bracket on a wall or post horizontally, at approximately
1~1.25m above ground level.
The mounting bracket has 4 holes, for each there is a corresponding screw.
Bracket installation on wall (see Fig.2+3)
Fig.2: Use the wall bracket to mark the position of the 4 holes on your chosen location.
Fig.3: Drill the holes with 12mm drill bit at 50mm deep.
Insert the masonry plugs into the holes (use hammer if deemed necessary).
Position the wall bracket and insert screws into plugs and then tighten accordingly.