KIKKA BOO LITTLE TRAVELER Instrucciones De Uso página 5

IV
Securing the baby wit h the haness .
Firstly, adjust the shoulder straps height( see point ADJUSTING THE SHOULDER HEIGHT) proceed as follows:
Step 1.Loosen the harness (see point above), open the buckle, and place the down side ways. Seat your child in the chid car seat .Place both
shoulder straps over your child's shoulders.
until they "click" into place (fg. 2)
V
Tighten the shoulder harness.
Pull the shoulder straps upwards to remove the whole harness then pull the adjuster strap until the harness is fully tightened.
The harness should be adjusted as tightly as possible with out causing discomfort to your child. To release the harness (see point ADJUSTING THE
SHOULDER HEIGHT),press the red button on the buckle downwards.
SECURING THE INFANT CARRIER
Please read the operating handbook in your vehicle to inform yourself about the basics concerning children's seats in vehicles. DO NOT place this baby seat
on seats with front airbags. This baby car seat can only be installed using a three-point vehicle belt. The baby car seat must be Installed rearwards facing.
VI
VII
Slide the lap belt of the Vehicle's 3-point seat belt through both Lap belt guides. Let the tongue plate snap in the belt lock with a clearly audible
"click. Pull the shoulder belt in narrow direction to tighten the lap belt. Check to make sure the tongue plate is locked by pulling on the belt(Fig.
VII).
VIII
Place the diagonal belt in the diagonal belt guide at the back of the seat(Fig. VIII)
IX
X
The satisfactory position of the adult safety-belt buckle car seat relative to the child is as the Fig 5. You can contact the child rer if in doubt car seat
manufactu about this point.
in any way. To release your baby car seat following the above instructions in reverse order.
SNAPPED THE HANDLE
XI
The handle for the baby car seat can be snapped into 4 stable positions . To adjust the handle, please press the red butt on of handle on both side
at the same time. Now it can be rotated.
XII
The carry handle has four positions:
1. Forward facing Install d in the car. This position (on ly thi s posit on )is suitable for the baby car seat instaled on the vehicle seat.
2. Straight up for carrying
3. Hand e clicked back to initiate the rocking feature
4. Down to support baby for feeding and play
CANOPY USE
XIII
Depend on the elastic deformation, Insert keys on both ends of canopy frame can be up-down adjusted. When you heard the "click", the side of
canopy frame should be located.
MAINTAIN AND CARE OF YOUR PRODUCT
REMOVE (CLEAN) THE COVER
The cover can be easily removed for washing. Remove harness by pressing the harness and loose the shoulder straps to release buckles; then remove the cover
to wash in warm water. Follow reverse of the above to replace the cover.
CLEANING THE CAR SEAT
The harness and plastic parts can be washed with very mild detergent and warm water. Do not use chemical cleansers, bleach or corrosives to wash any part
of the car seat.
ENGLISH