TRENDnet TEG-424WS Guía De Instalación Rápida página 4

Troubleshooting
1. After connecting the TEG-424WS to a power outlet, the LEDs do not turn
on.
1. Check the connection of the power cord to the TEG-424WS and the power
outlet.
2. Check that the power outlet is receiving power.
2. When I access the TEG-424WS using a web browser, I get a screen that
tells me "only one user can login". What should I do?
Another computer is configuring the TEG-424WS. Please wait until the user
logs off. If the other user has already logged off and you still get the same
screen, then disconnect the power cord from the TEG-424WS, wait for 5
seconds, reconnect the power cord to the TEG-424WS, allow 5 seconds for
the switch to power on, and then attempt to access the web configuration
page again.
3. I forgot the administration password. How do I reset my TEG-424WS?
Press on the reset button using a pen or paperclip for 10 seconds. The default
password is admin. Note: The default password is case sensitive.
4. When I connect a computer to the Switch's Gigabit Ethernet port, I am
not getting Gigabit speeds. What should I do?
1. Check the LEDs on the Switch. When the 1000Mbps LED is off, the
computer's connection speed is 10 or 100Mbps.
2. Make sure that you have a Gigabit Ethernet adapter installed.
3. Make sure to use a Cat. 5e or Cat. 6 Ethernet cable. Some Cat.5 cables
are not rated to run in Gigabit.
If you still encounter problems or have any questions regarding the
TEG-424WS, please refer to the User's Guide included on the provided
CD-ROM or contact Trendnet's Technical Support Department.
3