ShelterLogic Shed-in-a-Box Manual De Ensamblaje página 7

5. sqUAre tHe FrAMe
A. Place frame in its final location, which
needs to be as flat and level as possible.
B. Measure across opposite corners (X & Y).
These distances must be equal to within
1 inch.
C. Check that the front and rear of the frame
measures 12 ft. 3 in. wide.
6. properlY AncHor tHe FrAMe
A. Anchors must be placed inside shelter at the corner legs. Insert a ¾-inch pipe or steel rod through the eyelet
of the auger and turn the anchor clockwise until the eyelet is sticking out of the ground 1 to 2 inches allowing
room to be anchored to the legs.
TIP
B. Thread cable provided through the eyelets of the Anchor as indicated in figure. Secure the cable with the
clamps provided.
If soil is too compact, dig a hole with a shovel or post hole
tool. Set anchor in hole and refill. For a stronger, more
secure installation, fill hole with quick-set cement.
Page 7
X
Y
12' 3"
NOTE:
15" Augers are for temporary use only!
For best results ShelterLogic recommends
using our Easy Hooks (#10036 4-pack,
#10035 6-pack, or #10038 8-pack) or 30"
Augers (#10075 4-pack, #10078 6-pack, or
#10079 8-pack) for a stronger, more secure
installation.
Call 1-800-524-9970
or visit
www.shelterlogic.com
for more information.
WARNING:
Serious injury to persons
or property could result if
cover is installed and shelter
is not anchored and is left
unattended. Shelter must be
securely anchored before use.
12' 3"
05_70443_70743_F3