KIKKA BOO SPORT Instrucciones De Uso página 34

4.
Step 1. For group 0, the child safety seat must be used in the most reclined position (see Fig 1 a). The safety seat must never be used
in any other position(see Fig 1. b). To adjust the reclining position of the safety seat, pull the red handle (J) forward until the backrest
is in the most reclined position. Adjust the position of the base as shown, and then press the red button, until heard "clicking" sound.
Step 2. The child seat must be always rear-ward facing (Fig. 3). If your car has airbag on the passenger seat, the safety seat must only
be used on the rear seats in the vehicle (Fig. 1 c).
Step 3. Secure the safety seat onto the car seat using the car seat belt (see Fig 3).
Step 4. Pass the lap part of the seat belt under the base of the safety seat into the two points marked by a blue label (A) and fasten
the clip to the corresponding buckle (M).
Step 5. Pass the upper diagonal part of the belt in the upper guide (B).
Step 6. Take the red Lock-o clip ( D) and attach it to the shoulder belt directly above the buckle (Fig.4.) .
Step 7. Make sure that the belt is not twisted and strongly tightened before the Lock-o clip is fastened.
Step 1. The basic wedge must be in position A when used forward facing.
Step 2. Fasten the child seat in forward facing position on rear seat of your car using the 3 point belt system which is installed in the car.
Step 3. Pass the 3 point belt system (lap and shoulder belt) through the red marked openings (Fig.4) (K1and K2) AND THROUGH THE
UPPER GUIDE (B). Fasten the buckle (M) in the lock until a click is heard (Fig 5.).
Step 4. At the same time the lap belt is pulled through the 2 plastic holes.(Fig.4).
Step 5. Place and fasten the red Lock-o clip (D) on the shoulder belt directly above the buckle. (Fig. 5).
-
:
18 .
.
5.
5.1
5.2
5.3
5.4
5.5
6.
•
•
•
.
•
.
•
.
•
•
•
•
•
•
1
.
.
.
,
,
.
.
.
0 (0-9 KGS)
I (9 18 KGS)
30 ° C
,
.
,
.
.
9KGS.
.
.
.
.
.
.
,
.
,
9
,
.
.