Ecoflam E-BCU Diagnostic tool Manual De Uso página 6

EN
Menus overview
• 1) Flame signal time
(last burner ignition).
• 2) Average flame
signal time (referred to
last 5 burner ignitions).
• 3) Total burner
ignitions.
• 4) Total burner running
hours.
• 5) Total stored lock-
outs.
• 6) Total burner
ignitions from last couter
reset.
6 www.ecoflam-burners.com
Pushing button BP2 the following infos are
available (sequence):
BP2
• 7) Total burner running
hours from last couter
reset.
• 8) Total stored lock-
outs after last couter
reset.
• 9) Total burner
ignitions after last lock-
out reset.
• 10) Burner running
hours after last lock-out
reset
• 11) Burner lock-outs
due to flame signal
during pre-purge.
• 12) Burner lock-outs
due to lack of flame
signal after safety time.
• 13) Burner lock-outs
due to lack of flame
signal during burner
operation.
Only for gas version
• 14) Burner lock-outs
due to lack of air
pressure switch signal.
• 15) Not used.
Only for oil version
• 16) Burner lock-outs
due to oil pre-heater.
420010145602