Safety Precautions - HQ CAR-START01 Manual De Uso

• Please follow your local authorities guidelines with regards to the proper recycling for Ni-MH
batteries, should you dispose of the product
• Recharge the battery after every use
• It is recommended that you initially charge the unit using the supplied AC adapter
• The unit should be charged every 12 months regardless of use using the AC adapter
• Keep out of reach of children
• Do not attempt to reverse the polarity
• An automatic thermal and current protector is fitted in the charger
• Avoid staring into the beam of the LED for any period of time
Charging a Weak Battery
1. Be sure that the unit is not connected to the vehicle before attempting to start the vehicle.
2. Turn off all electrical accessories (e.g. fan, radio, wipers etc).
3. Make sure the cigarette lighter socket is clean and free of debris.
4. Plug the unit into the cigarette lighter socket and turn the power switch to the ON position.
5. If your vehicles 12 V cigarette lighter / power source is off when the ignition is off, then set the ignition
key to "accessory position" during the re-charging process.
6. Allow to charge for 15 to 30 minutes.
7. Remove the unit from the vehicles power source and attempt to start the vehicle.
8. Do not attempt to start the vehicle more than 3 times.
Charging the power source pack
Charging with the AC adapter
1. Insert the AC adapter into a 230 volt socket and plug into the adapter socket on the unit, the self
charging switch needs to be OFF.
2. The charge indicator will illuminate, indicating the internal battery is being recharged.
Note: After purchase, the jump start will require charging to be full before initial use. Charge it for
5-8 hours.
Charging the battery from the car
1. Insert into the vehicles cigarette lighter / power source while the engine is running, the self charging
switch needs to be ON.
2. The charging indicator will illuminate, the unit will now be recharging from the vehicle's battery.
Note: Do not leave plugged in when the engine is not running.
Using the jump starter as power source
1. Before connecting any 12 V DC accessory, check the polarity.
2. Do not use any products that have a different polarity, or products that do not operate at 12 V or have
a different connector type.
3. Simply plug the product into the 12 V outlet socket on the unit and turn the power switch to ON.
Checking the level of battery power
Turn on the power switch, the indicator (5) shows the status of the battery.
Green: Battery is strong
Orange: Battery almost needs to be recharged
Red: Weak battery, recharge before use
LED Light
Press the switch (1) to use the LED torch function.

Safety precautions:

To reduce risk of electric shock, this product should ONLY be
opened by an authorized technician when service is required.
Disconnect the product from mains and other equipment if a
problem should occur. Do not expose the product to water or
moisture.
3