Publicidad
Idiomas disponibles
Idiomas disponibles
MOV-049
UNIVERSAL TRIPOD FOR CAMERA
AND SMARTPHONE
Instruction manual
DESCRIPTION
Universal screw
Side tilt adjustment knob
Level
Front and rear tilt
adjustment handle
Rotating
adjustment knob
Central adjustment knob
for column
INSTALLATION
1
2
Loosen the center knob and
remove locks to release the
segments.
4
Once you have adjusted the height, place
again the locks again, and tighten the center knob,
so that the segments are fixed.
6
Put the smartphone holder or a camera in the universal screw.
OPTION A
Tighten
V0.0
0517m
Smartphone
holder
3
Pull the segments and
choose the desired height.
5
Place the tripoid on a flat surface.
OPTION B
Tighten
IMPORTANT
Read these manual to avoid any damage.
The instructions of these manual are for reference about the product.
There may be differences due to update.
Please check our web site www.steren.com to obtain the latest version of the instruction manual.
CAUTIONS
• This product is not a toy; keep out of reach of children.
• Don´t place the tripoid on unstable places.
• This product is not intended for use by persons with different abilities, unless that are supervised or instructed by
a person responsible for its safety.
• Any unauthorized repair may cause malfunction and void the warranty.
The operation of this device is subject to the following two conditions: (1) it is possible that this device may not cause harmful interference and (2) this device
must accept any interference, including interference that may cause undesired operation.
ADJUSTING BASE
If you want to rotate the base or adjust the front or rear tilt, loosen handle and rotating adjustment knob,
adjust and, at the end, tighten again the handle and knob.
A
Loosen the knob and adjust the side tilt, at the end, tighten again the knob.
A
BLUETOOTH CONTROL
1.
Slide the switch to turn on the control and put it in Bluetooth searching mode. The LED indicator will continuously turn on
and off
2.
In the Bluetooth options in your smartphone, search and select Steren Mov-049. Once the connection is established, the
LED will turn off
3.
Depending on the operating smartphone system, press the action button of the control to take a picture.
Button for
Button for
REPLACING BATTERY
Insert a CR2032 battery. Make sure the polarity is correct.
SPECIFICATIONS
Specifications may vary without previous notice
Control
Input: 3 V - - - (CR2032)
Operating frequency: 2.4 GHz
C
B
B
C
Publicidad
