asalvo 151505 Manual De Instrucciones página 12

· The bedguard is not recommended for use by children under the age of 18 months or
when the child is over the age of 5 years, and onlywhen the child is able to climb in and
out of the bed unaided.
· The bedguard should not be used as a substitute for a cot, as it cannot provide the
same level of safety as a cot.
· The maximum thickness of mattress for which the bedguard is suitable is 20 cm.
side of the mattress.
EN
should be obtained only from the manufacturer.
· The bedguard should not be used on a sleeping surface that is more than 600 mm from
the floor.
· Washing instructions for mesh panels: Hand wash at 20 ° C.
· Not suitable for use with elderly or sick adults, or for use in a non-domestic environment.
· Bed size: min 200 cm. And max 220 cm.Mattress size: minimum length 200 cm.
Maximum length of mattress 220cm. Mattress thickness between 10 and 20 cm.
Mattress width between 90 and 100 cm.
To prevent the risk of strangulation it is essential to ensure that
least 10 inch (250 mm), between each end of the bed and the
250 mm.
IMPORTANT
Do not use the rail if any part of it broken.
corresponding end of the Side rail.
Imported by: Estar Asalvo S.L.
Pol. Ind. Hacienda Dolores, 2, C/2
41500 Alcalá de Guadaíra - Sevilla - España
CIF.: B91234286
place securely attached to both the bed
and/ or the mattress and the bedguard.
should be checked to ensure that it is
· The bedguard should be periodically
checked for its general condition with
particular reference to the security of
any locking mechanism and hinges
that are used on the product.
· Additional and replacement parts
WARNING
250 mm.