Taurus TANGER 600 Manual De Instrucciones página 12

- Fit the appliance into the wall support.
FITTING THE BASE FEET
- The appliance has some base feet(Fig4) on
which the product can be supported.
- To assemble the base feet, place the appliance
face down.
- Fit the base feet on the main body of the
appliance.
- Attach the base feet to the body of the ap-
pliance using the screws (Supplied with the
appliance).
- Stand the appliance up again so as to check
that the base feet work properly.
INSTRUCTIONS FOR USE
BEFORE USE:
- Remove the appliance's protective film.
- Make sure that all the product's packaging has
been removed.
- Some parts of the appliance have been lightly
greased, consequently, the appliance may give
off a light smoke the first time it is used. After a
short time, this smoke will disappear.
- To eliminate the smell given off by the appli-
ance when used for the first time, it is recom-
mended to have it on at full power for 2 hours in
a well-ventilated room.
- Prepare the appliance according to the function
you wish to use.
USE:
- Unroll the cable completely before plugging it
in.
- Connect the appliance to the mains.
- Turn the appliance on using the on/off switch
(D1)
WHEN YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off, using the on/off switch
(D1).
- Unplug the appliance to the mains.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
CLEANING
- Disconnect the appliance from the mains and
let it cool before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
to clean the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Do not submerge the appliance in water or any
other liquid, or place it under a running tap.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
- Note: When the appliance is switched on
during the heating function, after a long period
stopped or operating only in fan mode, it is
possible that at first it releases some smoke,
without any consequence, because dust and
other particles accumulated in the heating
element are burning. This phenomenon can be
avoided by cleaning up previously and through
the vents of the appliance and its interior with
the help of a vacuum cleaner or with a jet of
compressed air.