TEMPErATurE CONTrOL
HOT WATER
The water in the hot tank is heated by a band type heater. A temperature sensor
(Bi-metal) is attached to the hot water tank, which controls the water temperature.
A secondary over-heating prevention sensor (Bi-metal) is attached to the hot water
tank, which will prevent the heater from overheating.
Please turn off the hot water switch on the back panel when not using hot water.
COLD WATER
The water in the cold water tank is cooled by a Compressor Cooling System. The
temperature of cold water is sensed and controlled by a thermostat. The cooling
time depends on the environmental conditions where water dispenser is used.
PrOPEr CArE ANd CLEANING
Caution! B efore using any cleaning product, always read and follow the
manufacturer's instructions and warnings to avoid personal injury
and/or product damage.
Note: I t is best to clean the unit and its surrounding area in between
replacing the empty bottle with a new one. This way you can move the
unit easily without the weight of the bottle.
GENERAL
• P repare a cleaning solution of 3-4 tablespoons of baking soda mixed with
warm water. Use a sponge or a soft cloth dampened with the cleaning solution
to wipe down the unit.
Always unplug the unit before cleaning
to avoid electric shock. Failure to do so
may result in death or injury.
• Wipe with clean warm water and dry with a soft cloth.
• D o not use harsh chemicals, abrasives, ammonia, chlorine bleach,
concentrated detergents, solvents or metal scouring pads. Some of
these chemicals may dissolve, damage and/or discolor the unit.
• T he spilled water in the drip tray must be removed regularly and cleaned
properly to avoid any bacteria and residue build-up.
• W e recommend that you clean the water dispenser at least twice a year.
When cleaning, you do not need to take anything apart.
WARNING!
English
8