Genie 250 CD Manual Del Usuario página 9

3. The switch should be set to OFF if you wish to empty the paper basket, or do not intend to
use the device for an extended period. After doing so, unplug the device from the power
supply.
The device is only intended for personal use indoors and for a short operation
period of a maximum of 2 minutes. Do not use the shredder for commercial
purposes or outdoors.
Shredder capacity:
The 250 CD is capable of shredding up to 7 sheets of paper (DIN A4, 80g
width may not exceed 22cm. When shredding small pieces of paper, such as envelopes or
credit card receipts, the paper should be inserted in the middle of the opening. Please ensure
that you never insert more than the stated maximum quantity into the cutting unit as this may
damage the device.
Separate cutting unit for CDs and credit cards
This shredder is fitted with a separate cutting unit for CDs/DVDs and credit cards. CDs/DVDs
are cut into 3 sections. Keep your face at a suitable distance from the device when inserting
CDs/DVDs since these materials are at risk of splitting. The shredded material is collected in a
separate container which will help you dispose of the waste in an environmentally-friendly
manner.
How to operate:
Set the switch on the front side to "AUTO". The device will then be ready to operate.
Shredding paper
Insert a maximum of 7 sheets of paper (80g/m²) in portrait orientation into the input slot. The
paper will be recognised by the sensors, the cutting unit will start and the paper will be
automatically drawn in. The operation will finish once there is no more paper in the cutting unit.
Overloading:
If you insert too much paper, the cutting unit will stop. In this event, set the switch to "REV" in
order to remove the paper. Reduce the number of sheets and then try again.
Overheating:
If you exceed the indicated maximum operating time of 2 minutes, there is a possibility of the
motor overheating. In this event, the cutting unit will stop. The drive will be automatically
disconnected from the power and will restart on its own once the motor has cooled down
sufficiently. You should therefore set the switch to the "OFF" position and let the device cool
down for an appropriate length of time. The maximum continuous operation time of 2 minutes
can only be reached with a sufficiently cool device. Cooling the device down sufficiently to
operate it again for 2 minutes takes around 60 minutes.
Removal of leftover paper:
Set the switch to "OFF" and unplug the power socket. Remove the shredding attachment and
then you will able to take out any scraps of paper that have become caught in the cutting unit.
The blades are very sharp so you should proceed with extra caution! Place the shredder
:
- 9
-
) at once. Paper
/m²