Support - Retro-Bit SEGA SATURN Manual De Instrucciones

ANDROID®
1. On the Android® device, enable Bluetooth® mode.
Press A + Home to turn on the controller. The LED1 will flash while searching and remain
2.
solid when connected.
AMAZON®
1. On the Amazon® device, ensure device and displays are both on and enabled.
Press A + Home to turn on the controller. The LED1 will flash while searching and remain
2.
solid when connected.
Press L + R + Start for 3 seconds will change the D-Pad to left analog. Repeat this to
3.
return it back to D-Pad mode.
PC WINDOWS®
1. Plug in the Micro USB cable from the controller to an open USB® slot on the PC. By
default, the controller is in X-Input mode. LED2 will remain flashing while charging and
remain solid when fully charged.
Hold B while connecting the controller to the PC to enter D-Input mode. LED3 will remain
2.
flashing while charging and remain solid when fully charged.
X-Input/D-Input with vibration: Press and hold L + R + Start for 3 seconds to change into
3.
D-Input mode. LED4 will remain flashing while charging and remain on when fully charged.
Hold L+R+Start for 3 seconds again to return the buttons to their original state.
MAC®
1. On your Mac® Device, ensure Bluetooth is enabled.
Press Home + X to turn on the controller. The LED3 and LED4 will flash while searching
2.
and remain solid when connected. You may need to accept the connection on your Mac®
device before proceeding.
PS3®
1. Plug in the Micro USB® cable from the controller to an open USB slot on the PS3® while
holding Select.
2. The LED1 will stay on then press the Home button. LED1-4 will indicate the player.

SUPPORT

To keep up to date on the latest firmware, please visit www.retro-bit.com/support.
5