Safety Regulations; Symbols In This Manual; Symbols On The Machine - Rapid 100E Manual Para El Usuario

IntrodUCtIon
This Operator's Manual describes the Rapid 100E.
Read the operator's manual carefully before using the machine.
The manual contains safety regulations and descriptions of checks on parts
which are critical for safety, together with directions for the correct use and
maintenance of the machine. The figures will be found on the cover fold-out.

SafEty rEgUlatIonS

- The machine may only be used by personnel with knowledge of the safety
regulations and correct handling as described in this manual.
- The visor must always be folded down when stapling.
- Only the papers (or other objects) to be stapled should be put into position
under the visor.
- It must not be possible to staple with the visor in the upper position. Check
on this every day as described in the section "Checking safety functions".
- The machine must be turned off before it is moved.
- The machine must be connected to an electric socket which has a
protective earth.
- The machine must not be subjected to moisture. It must not be located in a
position where rain or splashes of water can fall on it.
- Repairs and other measures, besides those described in this manual, must
be carried out by authorised service personnel.
- Repair of faults or damage to the machine or its electrical connection must
be carried out by authorised service personnel.
SymbolS

Symbols in this manual

Read the operator's manual carefully and make sure you understand
it properly before using the machine.
Warning text. Information critical for safety follows after this symbol.

Symbols on the machine

See figure 1.
A Forbidden to put fingers underneath the visor when it is folded down.
B Adjusting the stapling power.
gb
31