Makita DFL201R Manual De Instrucciones página 6

Lights up in
A series of
red and green
short beeps
alternatively.
Blinks in red A series of
quickly. short beeps
Green (blue
when batch is
completed in
tool stand-
alone mode)
Lights up in
A long beep
red.
007930
Status of
the LED indicator/beeper
LED indicator Beeper
Lights up in
A long beep
yellow.
Blinks in red
and yellow A long beep
alternatively.
Blinks in red
A series of
and blue
short beeps
alternatively.
011058
Note: These values can be changed on PC. Refer to SRCV02 USER MANUAL for details.
6
This function works when an abnormal
Anti-reset of
drop of the battery voltage occurs for
controller
some reason, and the tool stops.
Failure of motor This function works when motor fails.
This function works when the
Overheat temperature of the controller or motor
goes up very highly, and the tool stops.
This function works when the tool has
Auto-stop reached within the fastening torque
fastening range preset on PC and normal
tightening has been completed. (Note)
Result of torque This function works when the tool has
judgment: NOK reached above the fastening torque
(High) range preset on PC. (Note)
Function
Result of torque This function works when the tool has
judgment: NOK reached below the fastening torque
(Low) range preset on PC. (Note)
Warning against Fastening is incomplete when switch
insufficient trigger of tool is released before clutch
fastening activation.
Double-hitting This function works when a screw is
detection refastened after fastening.
This function works when a screw is not
Angle judge NOK fastened within the angle range preset
on PC (Note).
This function works when a fastening is
Rundown NOK finished before it reaches the preset
angle range. (Note)
Torque impossible This function works when torque
monitoring monitoring is cannot be carried out.
Disconnection
Radio communication not yet
(when using
established
receiver RCV02)
Radio
This function works when there is radio
communication
communication failure.
failure
Status
Replace the battery
with fully charged
one.
Take it to a Makita
Authorized Service
centers.
Remove the battery
cartridge immediately
and cool the tool
down.
__
__
Action to be taken
__
__
__
__
__
__
Finish necessary
connection or remove
a battery cartridge to
escape.
Take it to a Makita
Authorized Service
centers.