JOCCA 1143 Manual De Instrucciones página 6

EN
-This appliance is protected against overheating; this
means that if the appliance overheats it will switch
itself off automatically. If it switches itself off during
use, put the temperature selector in the 0/Off position
and wait for about 5 minutes.
-A differential circuit breaker with a maximum of
30mA as additional protection is recommended in the
electricity installation used for the appliance. Please
ask a qualified installer for advice.
INSTRUCTIONS FOR USE
-With wet hair, firstly towel dry hair and then use the hair dryer.
-Make sure that the on/off switch is in
from the mains.
-Do not use a spray or inflammable chemical products to care for your hair.
-Plug it into a socket and place the switch in the appropriate position
depending on the air flow and temperature required for the type of
drying.
-If you wish to dry your hair with cold air keep the cold air button pressed.
This button works independently from the temperature and speed selector
position.
-Speed selector: Thanks to this switch, we can start the appliance up,
switch it off and select the desired temperature and air flow volume.
Appliance off
Low air flow volume
High air flow volume
-Temperature selector:You can select the desired temperature.
Low temperature
Medium temperature
High temperature
-Unplug the appliance from the mains when you have finished using it.
Dual Air Design: Double cascade flow
Open dryer nozzle (FIG.1: image of the dryer with open nozzle)
- With the dryer off, turn the nozzle until the top and bottom openings are
open.
- With the hair damp and untangled, separate hair into locks of 3-4 cm.
- Turn on the dryer .
- Take a lock of hair and slide it into the dryer's open nozzle .
- Slide the appliance down, as if combing it, repeat the process until you
consider that it is sufficiently smooth or with desired shape.
position before unplugging it
6