Parts List - Teka Universe Pro 790027200 Instrucciones De Instalación

PARTS LIST

1. Wall Plug (x2)
2. Fixity1 (x1)
3. Screw (x2)
4. Fixity2 (x1)
5. Flange Cover (x1)
6. Shower Arm (x1)
7. Shower Head (x1)
TOOLS REQUIRED
Power drill, ø 6mm masonry drill
bit, screwdriver, pencil.
BEFORE YOU START
The screws and wall plugs sup-
plied are only suitable for use on
solid walls. For hollow /plaster-
board walls, purchase appropriate
fixings.
Please ensure there are no hidden
service pipes or cables where you
intend to drill.
The working pressure of this prod-
uct is 0.5kgf/cm2 - 6.0kgf/cm2.
The recommended water pressure
is 2.0kgf/cm2 - 5.0kgf/cm2.
Please be careful of your safety
while drilling and installing.
This product has passed the func-
tionality test before leaving the
manufacturer.
INSTALLATION
Install the fixity 1 and fixity 2:
• Drill two Ø 6 mm holes in the wall
approximately 850 mm apart. The
depth of holes should be no more
than 35mm. Insert the wall plugs (1)
into the holes.
• Screw the fixity1 (2) and the fix-
ity2 (4) into the wall with the tapping
screws (3). Adjust the distance be-
tween the fixities to be 850 mm.
Tighten them into the wall.
• Align the shower bar with the
fixiy1 and fixity2 and install it into
them. Tighten the grub screws
found at the end of ceramic shower
arm diverter and shower arm.
• According to the installation
sketch map, screw the shower arm
(6) into the bar (11).
• Install the shower head (7) onto
the shower arm.
8. Hand Shower (x1)
9. Hose(L=1,5m) (x1)
10. Slider (x1)
11. Bar (x1)
12. Ceramic Shower
Arm Diverter (x1)
13. H ose(L= 0,8m) (x1)
• Connect the swivel nut of the
short hose (13) to the underside
connector of the ceramic shower
arm diverter, and connect the other
end of the short hose to the shower
faucet connector.
Install the hand shower:
• According to the installation
sketch map, connect the long hose
(9) to the underside connector of
the ceramic shower arm diverter.
Connect the other end of the long
hose to the hand shower (8).
• Press the slider button and adjust
the height of the slider according to
your preference.
Check the installation step by step
to ensure stability and tightness
and to avoid any leaks before test-
ing the shower spray.
USE OF CERAMIC SHOWER ARM
DIVERTER
• The ceramic shower arm diverter
controls the hand shower and the
shower head.
• Turn the ceramic shower arm di-
verter handle to the vertical posi-
tion to direct water to the shower
head.
• Turn the ceramic shower arm
diverter handle to the horizontal
position to direct water to the hand
shower.
• Turn the ceramic shower arm
diverter handle to the position be-
tween 1 and 2 to direct water to
both the shower head and the hand
shower.
MAINTENANCE
Keep the slide rail clean. Clean only
with a mild non-abrasive detergent
and soft cloth.
GB