Waste Disposal And Environmental Protection - IKRA Hurricane HEMI 1200 Instrucciones De Manejo

Troceadora a motor
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37
Attention! Electrical repairs may only be carried
out by a skilled electrician or a customer service
workshop!

Waste disposal and environmental protection

If your device should become useless somewhere in the
future or you do not need it any longer, do not dispose
of the device together with your domestic refuse, but
dispose of it in an environmentally friendly manner.
Please dispose of the device itself at an according
collecting/recycling point. By doing so, plastic and
metal parts can be separated and recycled. Information
concerning the disposal of materials and devices are
available from your local administration..
Troubleshooting
Fault
The motor cannot be
started.
Unusual
sounds
Unusually strong
vibration
Bad tilling result
Possible cause
No power
Cable damaged
Safety switch/plug combination
damaged
Overheating protection is activated
Tines are blocked
Lubricating agent is leaking
Screws, nuts or other fastening
elements are loose
Tines are damaged or worn out
Working depth too deep.
Working depth too low.
Worn-out/blunt tines.
Rectification
Check mains supply.
Check cable, pull the plug and insert again,
if required, replace the cable or have it
repaired by a qualified electrician
Have the tool repaired by a specialist
workshop.
1. Working depth too deep, continue work with
less working depth
2. Tines are blocked, remove blocking.
3. Soil is too hard, adapt working depth accordingly
and work soil by repeatedly moving forward
and backward over the same place.
Let the motor cool down for about 15 minutes
before you resume your work.
Switch the tool off, wait until the motor fully
stops.
Have the tool repaired by a specialist
workshop.
Fasten all elements; if the sounds remain
contact a specialist workshop.
Replace the tines or have them checked by a
specialist workshop.
Adjust working depth to a suitable depth.
Adjust working depth to a suitable depth.
Replace the tines or have them checked by a
specialist workshop.
GB-5

Publicidad

Tabla de contenido
loading

Tabla de contenido