LD Systems Stinger Serie Manual De Usuario página 7

1 MICROPHONE INPUT
Balanced XLR microphone input.
2
GAIN MICRO
Adjust the input sensitivity of the microphone input with this gain control. Please regard that microphones
needing phantom power (condenser microphones for example) will not work at these inputs since they do
not supply a phantom power.
3 LINE INPUTS
Balanced XLR line input (mono).
4 GAIN LINE
Adjust the input sensitivity of the line input with this gain control.
5 LINE OUTPUTS
Balanced XLR output (mono). The two inputs (mic and line inputs) are mixed together according to the adjus-
ted levels and sent to this output. You can use this output to split the mixed inputs out to another active
speaker or amplifier.
6 VOLUME MASTER
This is the master volume control. You can adjust the overall volume of the amplifier–unit.
7
TREBLE
The treble control allows you to pad or boost high frequencies by -12dB respectively +12dB. (This function is
not available on the 8" and 10" models)
8 BASS
The bass control allows you to pad or boost low frequencies by -12dB respectively +12dB.
9 PROTECT
This LED lights up in case of a over-heating of the systems. The amplification module is then automatically
shut off. If this problem should occur often please contact your dealer or the servicing department.
10 CLIP
This LED indicates the Class D power amps' peak limiter has engaged to attenuate a maximum output
voltage excursion, or put simply, a clipping signal.
11 SIGNAL
This LED lights up when the unit detects an incoming signal
ACTIVE SYSTEMS FEATURES:
7