Steren PAR-030 Manual De Instrucciones página 17

To make the connections, note that this equipment is provided
Of 3-pin XLR connectors with the following pin configuration:
1 = tierra, 2 = DMX-, 3 = DMX+.
You can manipulate the lamps individually using a controller. Use a cannon
cable to connect the DMX IN input of the PAR-030 to the output of the DMX
controller.
In the lamp (s) you must select the operating mode d001 or A001 with the
MODE button. Then select UP and DOWN with a DMX start address of the
first channel.
Remember to assign one mode of operation to each lamp when you
connect the PAR-030 cascade.
Never use a «Y» connector to branch the serial link.
Do not connect the appliance to the power supply via a dimmer.
MODE OF USE WITH DMX
0.1 SEC 30S
DMX IN
DMX OUT
10.MIN 0
DMX IN
MIC
DMX OUT
MODE UP DOWN ENTER
CANNON CABLE
DMX IN
MIC
DMX OUT
MODE UP DOWN ENTER
MIC
MODE UP DOWN ENTER
5