Before First Use; Battery Charging - Kasanova KWI000010 Manual De Instrucciones

SCOPA ELETTRICA WIRELESS
11

BEFORE FIRST USE

Step I: Place the swivel sweeper head on the floor, ensuring that the handle attachment
side is facing upwards.
Step 2: Connect the lower extension pole with the built-in battery to the handle
attachment and charger inlet. Ensure that the locking tab is aligned with the notch in
the extension pole.
Step 3: Depending upon the length of the pole required, either connect the top
extension pole with handle to the lower extension pole or fora longer reach also
connect the mid-section extension pole.
Step 4: Plug the charger into the charger inlet at the base of the swivel sweeper handle
and plug the plug end into the mains power supply, then switch on. The indicator light
will illuminate to indicate that the battery is charging.
Step 5: To use the swivel sweeper, switch off the charger at the mains power supply
and
remove the charger from the charger inlet. Use the ON/OFF button located at the
swivel sweeper handle base to start the swivel sweeper.
Note: Keep the brushes free of fìbres, hairs, and other objects that could impede the

BATTERY CHARGING

To maintain the battery's longevity:
The swivel sweeper does not come charged. Ensure that prior to first use, the swivel
sweeper is charged for approximately 8 hours
Discharge the battery fully, before fully recharging again on next use.
Subsequent charges should then only require approximately 6 hours.
Do not leave the appliance plugged in to the mains power supply on charge for
extended periods of time when not in use as this will decrease the Life of the battery.