Starting Up (Fig. 6); Switching On/Off; Practical Tips - Robust RB-MG 12 Li Manual De Instrucciones

5.2 Triangular sanding/grinding plate
Fit the triangular sanding/grinding plate to use the
equipment as a delta sander/grinder.
5.2.1 Fastening the sanding/grinding paper
The Velcro fastener enables easy changing of
sanding/grinding paper.
Make sure that the vacuum extraction holes on
the sanding/grinding paper and the sanding/grin-
ding disk are aligned.

6. Starting up (Fig. 6)

6.1 Charging the battery (Fig. 1.4)
1. Take the rechargeable battery pack out of the
handle (Fig. 1), pressing the pushlock buttons
at the side to do so.
2. Check that your mains voltage is the same as
that marked on the rating plate of the battery
charger. Plug the battery charger in the so-
cket.
3. Plug the battery pack into the charging adap-
ter. The LED (a) will come on to indicate that
the battery pack is being charged. The tem-
perature of the battery may rise slightly during
the charging operation. This is normal.
If the battery pack fails to charge, check the fol-
lowing:
•
whether there is voltage at the socket-outlet
•
and check for proper contact with the char-
ging contacts in the battery charger.
If the battery pack still fails to charge, send
•
the battery charger
•
and the battery pack
•
to our customer services department.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the power of the cordless equipment
drops. Never fully discharge the battery pack. This
will cause it to develop a defect.
6.2 Switching on/off
Slide the switch (1) forwards to switch on the
equipment.
Anl_RB_MG_12_Li_SPK7.indb 22 Anl_RB_MG_12_Li_SPK7.indb 22
GB

6.3 Practical tips

•
Switch on the equipment.
•
Work away from the body.
•
Never move your hands into the direct vicinity
of the work area.
•
Use only plug-in tools which are in good wor-
king order and undamaged.
6.3.1 Plug-in tools
Sawing: Sawing wood and plastic.
Notes on working practice: When sawing, watch
out for foreign bodies in the material and remove
them if necessary.
Plunge cutting is allowed only in soft materials
such as wood or plasterboard.
Sanding/grinding: Surface sanding/grinding at
edges, in corners or hard-to-reach areas. Depen-
ding on choice of sanding/grinding paper for the
sanding/grinding of wood, paint, lacquer, etc.
Notes on working practice:
This equipment off ers particularly high perfor-
mance for the sanding/grinding of hard-to-reach
corners and edges. To sand/grind profi les and
channels you can also work with just the tip or
the edge of the sanding/grinding disk. Various
sanding/grinding papers are available, specially
designed for the diff erent types of material you
may be working on and the amount you wish to
remove from the surface. The amount removed
will depend largely on the choice of sanding/grin-
ding paper and pressure applied to the sanding/
grinding disk.
Scraping: Scraping off old paint or adhesives.
Notes on working practice: Move the plug-in tool
against the area you want to remove. Begin with
a fl at angle of incidence and little pressure. The
surface (e.g. wood, plaster) may be damaged if
too much pressure is used.
- 22 -
13.10.2016 09:46:07 13.10.2016 09:46:07