Denon Professional DN-508MX Manual De Instrucciones página 11

Output
Click the Output button at the top to view
the Output page where you can set the
levels, equalization, inputs, and mute status
of each zone.
If a zone is stereo, it will actually use 2
zones (e.g., Zones 1–2, Zones 3–4), which
will share the same output settings. If a
zone is mono, it will use one zone only.
Input Menu: Click this menu to select
which source is sent to the zone.
Signal: This light indicates that the zone is
sending out an audio signal.
Peak: This light indicates that the zone is
sending out an audio signal that is
"peaking" (exceeding 0 dB). If this
happens, lower the level of the Source or
Mic/Line fader.
Mute: Click this button to mute or unmute the source. The button will be highlighted when
muted.
Input: Click this button to open the Zone Input window. In this window, click and drag each
fader to set the audio signal level that each mic/line input sends specifically to that zone.
(This does not affect the levels that those inputs send to other zones.)
EQ: Click this button to open the Zone EQ window. In this window, click each menu to set the
frequency (Freq), Gain, or bandwidth (Q) of the 5 frequency ranges: Low, Mid-Low, Mid, Mid-
High, and High.
Source: Click and drag this fader to set the input level of the source you selected in the Input
Menu (described above).
Mic/Line: Click and drag this fader to set the overall level of the mic/line inputs. This setting
is applied in addition to the settings in the Zone Input window (described above).
Master: Click and drag this fader to set the zone's overall output level.
To Zone 5-8 / To Zone1-4: Click either of these buttons to jump to the lower or upper half of
the page, respectively.
11